The Advanced Guide to LED Skin Therapy

LED skin therapy uses low-level light from small LEDs, usually delivered through a mask or a handheld device. This guide explains the basics so you can choose a device and use it with confidence.

What the wavelengths mean

Light is measured in nanometres (nm). The devices in our range list their wavelengths on each product page:

  • 415 nm is blue light, found in our Silicone LED Facial Mask.
  • 630 nm is visible red light with an orange tint, also found in the facial mask.
  • 660 nm is a deeper visible red, used in our knee wrap, foot and ankle boot, and cap.
  • 830 to 850 nm is near-infrared light. You cannot see it, so the LEDs can look dim even while they are working.

Research into light-based wellness products is ongoing, and results differ from person to person.

Choosing a format

A mask covers the whole face and leaves your hands free. The Silicone LED Facial Mask is flexible, food-grade silicone with 114 LEDs, six brightness settings and a 10-minute default timer.

Building it into your routine

  1. Cleanse your face and dry it first.
  2. Put the mask on and start the timer. Follow the manual for session length and settings.
  3. Finish with your usual skincare.

Short, regular sessions are easier to keep up than long, occasional ones. Start with the default timer and see how your skin feels.

Keep it safe

  • Read the manual before your first session and follow the timer.
  • Follow the manufacturer's directions on eye protection, and stop if you feel any discomfort.
  • Talk to a healthcare professional first if you have a medical condition, are pregnant, take medication that affects light sensitivity, or have concerns about your skin or eyes.

These products are for general wellness use. They are not intended to diagnose, treat, cure, or prevent any disease.

See the Silicone LED Facial Mask